Herunterladen Inhalt Inhalt Diese Seite drucken

Lpcm Output; Dolby Digital Setup - Clatronic dvd 754 Bedienungsanleitung

Dvd-player
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

05-DVD 754 - GB 57
Digital Audio Setup Page
Digital Output
Here you specify the settings for the digital Audio output.
SPDIF Off: Output of an analogue Audio signal, but no digital signal.
All: Output of a digital Audio signal. Use this setting if your amplifi er is no
two-channel stereo amplifi er.
PCM only: Output of a digital Audio signal that is converted to a 2-channel
signal. Use this setting if your amplifi er is a two-channel stereo amplifi er.
NOTE:
If there is no Audio output, even though you connected the DVD-Player to an
amplifi er, you will most likely have chosen an incorrect setting for the Audio
output.

LPCM Output

Here you can set the sampling rate of the audio signal. Generally speaking, a
higher sampling frequency produces a better audio signal.

Dolby Digital Setup

Dual / Mono
The Audio output is normally in stereo. Here you have the possibility to choose
Mono-output instead of Stereo-output.
Stereo: The Audio output is in Stereo (default).
L-Mono: The Audio output is in Mono. In this case the signal of the „left"
stereo channel is transmitted to all speakers.
R-Mono: The Audio output is in Mono. In this case the signal of the „right"
stereo channel is transmitted to all speakers.
Mix Mono: The Audio output is in Mono. In this case the signal of the
„both" stereo channel is transmitted to all speakers.
Dynamic
The term „Dynamic" (Dynamic Range) describes the ratio of quietest and
loudest sound. If the dynamic range is very large, you will experience very
quiet and very loud sounds.
This may cause replay problems. Let us assume that you are watching a DVD
in a relatively loud environment. You can now increase the volume to be able
to hear also the very quiet passages, however with the disadvantage that
loud passages will be unacceptably loud. In this case it would make sense to
compress the dynamic range (i.e. reduce) and increase the output volume at
the same time.
Changing the default settings
Themen
22.01.2007, 9:04:46 Uhr
57

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis