Electrical Connection - BOMANN cb 177 Bedienungsanleitung

5...._05_CB_177
• Insert the plug in a duly installed 230V/50Hz protective contact socket. The
details can be found on the appliance's nameplate.
• Make sure that the appliance is switched off. (The light in the on/off switch is
off.)
1. Pull the lid of the water tank forwards. Fill the machine to the level correspon-
ding to the number of cups required with cold water.
2. Close the water tank lid.
3. Swing out the filter in the direction of OPEN .
4. Crease the lower fold of the paper filter (size 1x4) and insert it into the filter fun-
nel. Please ensure that the filter paper does not protrude above the filter funnel.
Then fill it with coffee powder (approx. 1 teaspoon for 2 cups).
5. Place the pot evenly on the base.
6. Press the switch to the "I" position (the LED in the switch lights up).
7. Your appliance is provided with a drip stop. By removing the pot, before the
water runs through the filter completely, it avoids that the coffee drips on the
base. If there is still water in the tank or filter, make sure that the pot is placed
back under the filter to avoid overflowing.
8. When the coffee stops flowing into the filter, you can remove the pot.
9. Switch off the appliance (the LED in the switch is off).
10. If you would like to keep the remaining coffee warm, the switch must remain in
the "I" position. The hot plate will keep the coffee warm until you switch the
machine "0".
Please ensure that you switch the device off as soon as there is no more coffee in
the pot.
De-scaling is necessary when the brewing time increases substantially. Use only
commercially available citrus acid-based de-scaler. Follow the recommended
instructions for use.
1. Always pull he plug before cleaning and wait for the appliance to cool down.
2. Clean the outside of the appliance, if necessary, with a slightly moist cloth with-
out any detergent.
3. Pull the open filter insert upwards out of its retaining device in order to clean it.
It can be cleaned in the usual manner in warm soapy water.
4. Do not immerse the pot in water. Wipe the outside with a moist cloth. You can
clean the inside with warm water. If necessary, use a soft brush.
23.07.2004 11:13 Uhr

Electrical connection

Operating
De-scaling
Cleaning
Seite 27
GB
27