Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
Reinsert all of the parts in the reverse order.
NOTE:
through the device two to three times in order to clean it.
Electrical Connection
Insert the mains plug into a properly installed socket with
earthing contact. For information please see the type plate on
the device.
Operation
•
Fold open the water tank lid.
•
rear water container, as shown on the water level indicator.
NOTE:
CAUTION:
•
•
Now close the lid of the water tank.
•
Place the pot on the trade.
CAUTION: ANTI-DRIP SYSTEM
Do not remove the lid of the pot. This activates the so-
called anti-drip system.
•
Your device has an anti-drip system. If the pot is
removed before all of the water has passed through
the base.
•
If there is still water in the tank, place the pot under-
•
Turn the device on.
NOTE:
•
The control lamp in the switch lights up.
•
The brewing process lasts approximately 10 minutes.
•
remove the pot.
•
Turn the device off. The control lamp goes out.
NOTE:
for example.
WARNING:
If you would like to make another pot of coffee immediately,
please turn the machine off. Allow it to cool down with the
water tank open in order to prevent hot water splashing out
Descaling
It is necessary to descale the coffee machine if the preparation
time becomes considerably longer.
•
base should be used for descaling.
•
Please use the quantities stated on the pack or instruction
•
After descaling, please boil fresh water without coffee in the
machine several times (approx. 3-4 times).
•
This will remove any residues from the descaling process.
•
Do not use this water for consumption.
Cleaning
WARNING:
•
Before cleaning, always remove the mains plug and wait
until the device has cooled down.
•
Do not immerse the device in water. Otherwise this might
CAUTION:
•
Do not use a wire brush or any abrasive items.
•
Do not use any acidic or abrasive detergents.
•
The exterior of the device should be cleaned as necessary
with a slightly damp cloth – without any additives.
•
ing in warm water. Use a soft brush if necessary.
Technical Data
Model: .........................................................................KA 183 CB
Power supply: ..........................................................230 V, 50 Hz
Power consumption: .......................................................... 900 W
Filling quantity: .................................................. approx. 1.5 Litre
Protection class: .......................................................................... Ι
Net weight: .......................................................... approx. 1.45 kg
course of continuous product development remains reserved.
This device has been tested according to all relevant current
CE guidelines, such as electromagnetic compatibility and low
voltage directives, and has been constructed in accordance
with the latest safety regulations.
-
19
Werbung
Inhaltsverzeichnis
