Electrical Connection - BOMANN cb 150 Bedienungsanleitung

5....-05-KA 2833
GB
• Insert the plug in a duly installed 230V/50Hz protective contact socket. The
details can be found on the appliance's nameplate.
• Make sure that the appliance is switched off. (The light in the on/off switch is
off).
1. Open the water tank lid.
2. Now fill with enough fresh cold water for the desired number of cups. You can
read the level on the water level display. Do not overfill the appliance.
3. Close the water tank lid.
4. Swing the filter out to the right. Fold the paper filter (size 1x4) along the lower
folding line and then place it in the filter funnel. Please ensure that the filter bag
is longer than the filter funnel. Then fill it with coffee powder (approx 1 teaspo-
onful for 2 cups). Then close the filter until it locks in place.
5. Place the coffee pot without the lid on the rest.
6. Switch on the appliance (the LED in the switch lights up).
7. The brewing lasts about 10 to 15 minutes.
8. Your appliance is provided with a drip stop. By removing the pot, before the
water runs through the filter completely, it avoids that the coffee drips on the
base. If there is still water in the tank or filter, make sure that the pot is placed
back under the filter to avoid overflowing.
9. When the coffee stops flowing into the filter, you can remove the pot. Then
screw the lid on to the pot in such a way that the button on the lid is pointing
towards the handle.
10. Switch off the appliance (the LED in the switch is off).
11. To pour the coffee, please press the button on the lid.
De-scaling is necessary when the brewing time increases substantially. Use only
commercially available citrus acid-based de-scaler. Follow the recommended
instructions for use.
1. Always pull he plug before cleaning and wait for the appliance to cool down.
2. Clean the outside of the appliance, if necessary, with a slightly moist cloth with-
out any detergent.
3. The filter holder can be washed as usual in warm washing up water.
4. Do not immerse the pot in water. Wipe the outside with a moist cloth. You can
clean the inside with warm water. If necessary, use a soft brush.
22
11.11.2003 11:02 Uhr

Electrical connection

Operating
De-scaling
Cleaning
Seite 22