Jacuzzi Designer Collection Serie Bedienung Und Wartung Seite 34

I
Repeat the procedure in the reverse order and make sure that
the ring (3) is fastened well
Rotating nozzles
29
i
I
( 29) Turn the ring anticlockwise, remove and extract the
nozzle from the nozzle body.
I
Remove residues and wash the various components with
water and liquid soap.
I
Repeat the procedure in the reserve order.
SHOWER ZONE
I
Maintaining and cleaning the shower column is quick and
easy: simply use mild, non abrasive liquid detergent.
Do not use scouring pads, detergent powders, acetone or
other solvents.
I
Use the specifically marketed products for cleaning the glass.
I
Proceed as follows if there is lime scale deposited on the
nozzles:
- turn the dial anticlockwise and force it to end of stroke; then
extract it.
- clean the dial by soaking it in liquid lime scale remover (do not
use metallic tools); when refitting it, make sure that it fits into the
pins on the nozzle.
I
To prevent the formation of lime scale on the taps, simply dry
the various components after use. To remove stains, use a cloth
and soapy water, rinse with clean water and dry. Do not use
abrasive pads, detergent powders, acetone or other solvents.
Models with thermostat mixer tap
Removing and cleaning the thermostat valve
The thermostat valve is provided with a net filter to withhold
impurities in the water. The filters could clog up in time and
decrease the performance of the mixer. Refer to the "Installation
manual" for how to clean the valve.
.
Tub and taps
I
Use only mild, non abrasive liquid soap for cleaning the tub.
Do not use scouring pads, detergent powders, acetone or
other solvents.
I
To prevent the formation of lime scale on the taps, simply dry
the various components after use.
Use a cloth and soapy water to remove stains, rinse and dry; if
you use specific products for chrome-plated (or painted)
surfaces, normally found in shops, be careful to prevent contact
with the surface of the tub.
I
In case of supplementary maintenance, e.g. concerning
electromagnetic components fitted under the tub rim or
concerning scratches and stains on acrylic parts may be carried
out specialised personnel only. In these cases, contact a Jacuzzi
Authorised Service Centre only.
Always use genuine Jacuzzi® spare parts for maintenance
and/or repairs requiring the replacement. The manufacturer
will not be liable for damage if this requirement is
disrespected.
Jacuzzi Europe S.p.A. recommends to contact your local
Jacuzzi® Service Centre for all operations and interventions
not described in this manual.
Headrest
I
We recommended using a clean cloth or soft brush and soap
to clean the headrest(s).
Maintenance of wooden parts
I
Normal recommended maintenance includes cleaning with a
cloth and soapy water. Do not use abrasive products and
solvents. We recommend contacting specialised personnel for
supplementary maintenance, if needed.
Maintenance of marble, granite or stone
I A protective multipurpose product is provided with the
surround. Apply to the surround after installation. Marble, stone
and granite (the latter to a less extent) are easily stained by acids
(citric acid, in particular) and by many other products commonly
found in the bathroom (cosmetics, essential oils, etc.).
The protective coating will be gradually consumed in time with
normal cleaning of the surround (use warm water and mild soap,
avoid liquid detergents) and must be re-applied when needed.
We recommend calling a marble-cutter or a specialised store for
purchasing the protective product most suitable for the type of
surround fitted around your tub and for suggestions concerning
the method and frequency of the application.
34