No Water Or Liquid; Models With Sanitisation System And Spotlight; Models With Two Pumps - Jacuzzi Designer Collection Serie Bedienung Und Wartung

NO WATER OR LIQUID

DURING THE SANITATION CYCLE
The electronic circuit checks the level of water in the tub and of
disinfectant in the tank: if the required conditions are not respected,
the cycle will either not start or stop and messages will appear to
help you solve the problem.
I
Insufficient water level: if the cycle does not start when the
button (D) is pressed and you hear a long tone, top up the water
to the required level and hold the button (D) pressed for
approximately 4 seconds.
I
J-MX 07 liquid reservoir empty: if the LED (E) starts blinking
for a few seconds after pressing the button (D), but the pump
does not start, you have one minute to pour disinfectant into the
tank. After filling, the pump will start again and the cycle will
resume as programmed. Otherwise, the cycle will stop.
I
The reservoir runs out while the liquid disinfectant is being
pumped into the water circuit (first part of the cycle): the
pump will stop and the LED (C) will go out, while the LED (E) will
start blinking. If liquid is poured into the tank within five minutes,
the cycle will resume until the programmed ten minutes are
reached. Otherwise, the cycle will stop. In the latter case, the LED
(E) will keep blinking for approximately 60 minutes, warning that
the sanitation cycle has not been completed and that the tank is
empty.
I
If the water drops under the minimum level during the
cycle (e.g. drain open): the pump will not start for the final
rinsing cycle (last minute of the cycle) or will stop during this
step. An intermittent beeping will be emitted to signal the
problem. The cycle will start automatically if the water level is
topped up within five minutes. Otherwise, the cycle is stopped
without other indications because the sanitation cycle is
practically complete.
Models with sanitisation system and
spotlight
25
F
F
A) air-water mixture adjustment knobs
B) hydromassage cycle on/off button
C) hydromassage cycle LED
D) sanitation cycle on/off button
E) sanitation cycle control/alarm LED
F) disinfectant tank cap (or flap)
G) spotlight on/off button
I Press the button (G) to switch the spotlight on; press it again
to switch it off.
I Refer to the instructions contained in the corresponding
chapters for how to start the hydromassage and the sanitation
cycle.
NOTE
I
Models with halogen spotlight have a device which prevents
lighting when the water level is lower. This prevents damage to the
spotlight by overheating if it is not fully submerged in water.
31
A D E B
G C
A G E C
D B