Classic" Hydromassage Instructions; General Features; Starting The Hydromassage Cycle; Sanitising The Water Circuit - Jacuzzi Designer Collection Serie Bedienung Und Wartung

"Classic" hydromassage instructions

GENERAL FEATURES

The hydromassage is activated by means of the buttons on the face
i
plate ( 21), where the air-water nozzle mixing knobs are also
arranged. A LED is present near the electronic button which lights
21
up when the pump is on.
A) air-water mixture adjustment knobs
B) hydromassage cycle on/off button
C) hydromassage cycle LED
NOTE
I
All the buttons installed on the tub rim are powered at very low
voltage for total safety.

STARTING THE HYDROMASSAGE CYCLE

I
Trip the master switch to turn the tub on.
I To enjoy a Jacuzzi® hydromassage, simply get into the tub and
press the start button (B).
When in the tub, the water level must completely cover the
i
highest nozzles ( 22).
NOTE
I
The hydromassage and suction nozzles of the tub will remain
closed when the hydromassage is off; press the button (B) to start
the pump and immediately open the suction nozzle. The
hydromassage nozzles will open after a few seconds.
A C B
B
A
C
22
The tub is provided with an electronic sensor which prevents the
pump from starting if the water level is lower than the minimum.
Therefore, if the pump does not start when the button (B) pressed
and you hear a long beep, add water and press the button again.
The pump will also stops if the water level drops suddenly, e.g.
when you step out of the tub. In all cases, the hydromassage can be
started again by pressing the start button after solving the problem
(power blackout, low water level, etc.).
I The hydromassage is programmed to last for approximately
20 minutes; the cycle will automatically stop after this time.
Press the start button (B) to stop the cycle before.
I Refer to the general instructions for use for how to adjust the
air-water mixture or the intensity of the nozzles.

SANITISING THE WATER CIRCUIT

If you wish to sanitise the water circuit of the tub (recommended
frequency: approximately once a month), we recommend to use J-
MX 07 disinfectant, purchasable from Jacuzzi® Service Centres and
Authorised Retailers.
For sanitization, you can use the same water used for hydromassage
so long as no soaps, oils, or cosmetic products have been used.
Otherwise, you can use "fresh" water (that is, by emptying the tub and
filling it again). In both cases, the water level, without anybody in
the water, must completely cover the highest hydromassage nozzles.
I To perform a sanitisation cycle, just pour 50 - 150 ml of J-MX 07
disinfectant liquid into the water (according to the amount of
water in the spa) and operate the hydromassage for about one
minute. Then allow the disinfectant to act for about 15 minutes
more. Finally, empty the tub.
NOTE
I
Operate the adjustment knobs on the face plate (A) to shut off the
air: this will prevent forming foam while the pump is running.
Also check that all the hydromassage nozzles are open.
29