Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting - Jacuzzi Designer Collection Serie Bedienung Und Wartung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 52
With two pumps and water
temperature maintenance system
(optional)
26
B
B1
B) hydromassage cycle on/off button (pump 1)
B1) hydromassage cycle on/off button (pump 2)
This is automatically operated with the water temperature
maintenance system.
B2) hydromassage cycle on/off button (pump 2)
Present in models without water temperature maintenance system.
STARTING THE HYDROMASSAGE
I Press the button (B) and/or (B1/B2): to light up the
corresponding LED.
I In applicable models, press the button (B1) to start the water
temperature maintenance system (this is a low-power electric
water heater, which lights up at the same time as the pump and
which compensates for the cooling of the water due to evaporation).
The heater is provided with a safety thermostat which turns it off
automatically when the water reaches a threshold of 40°C.
I Press button (B) and/or (B1/B2) to stop the hydromassage
before the time (the corresponding LED will also go out).
N.B.: In applicable models, press the button (B1) again to stop the
water temperature maintenance system.
NOTE
I
A special electronic device prevents starting the pump(s) if the water
level is too low and emits a long beep; in this case, add the necessary
amount of water and press the button (B) and/or (B1/B2) again.

Troubleshooting

TUB ZONE
I
The hydromassage does not start
B
Check that the master switch on the power line is on.
If beeps are signalled when you attempt to switch the
hydromassage on, it means that the water level in the tub is
too low: refer to the specific chapter.
I
The hydromassage stops by itself
B2
Check that there is no blackout.
The hydromassage time is preset by default for approximately
20 minutes and therefore stops automatically after this time.
Simple press the start button again..
If beeps are emitted, it means that the water level in the tub
is low (refer to the specific chapters).
I
Few air bubbles come from the largest nozzles
Check that the nozzles are open.
Set the air adjustment knobs.
I
The hydromassage is less effective
Turn the nozzles.
Clean the suction nozzle(s) as shown in the "Maintenance"
chapter.
Clean the hydromassage nozzles as shown in the
"Maintenance" chapter.
I
The pressure from the hand shower is too low
Unscrew the hand shower from the flexible hose and check
that filter is clean and free from lime scale.
I
The sanitation cycle does not start
Hold the button pressed for a few seconds for the control to
be accepted.
If beeps are emitted, it means that the water level in the tub
is low (refer to the specific chapters).
Add disinfectant if the LED of the corresponding button
blinks, (refer to the corresponding chapters).
32

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis