Emc Measures; Data Protection - Fronius Acctiva Easy 1202 Bedienungsanleitung

-
-
-
-
-
-
-
EMC Device Clas- Devices in emission class A:
sifications -
-
Devices in emission class B:
-
EMC device classification as per the rating plate or technical data.

EMC measures

In certain cases, even though a device complies with the standard limit values for emis-
sions, it may affect the application area for which it was designed (e.g. when there is sen-
sitive equipment at the same location, or if the site where the device is installed is close to
either radio or television receivers).
If this is the case, then the operating company is obliged to take appropriate action to rectify
the situation.

Data protection

The user is responsible for the safekeeping of any changes made to the factory settings.
The manufacturer accepts no liability for any deleted personal settings.
Maintenance and Under normal operating conditions, the device requires only a minimum of care and main-
repair tenance. However, it is vital to observe some important points to ensure it remains in a us-
able condition for many years.
-
-
Maintenance and repair work must only be carried out by authorised personnel. Use only
original replacement and wearing parts (also applies to standard parts). It is impossible to
guarantee that bought-in parts are designed and manufactured to meet the demands made
on them, or that they satisfy safety requirements.
Do not carry out any modifications, alterations, etc. to the device without the manufactur-
er's consent.
Dispose of in accordance with the applicable national and local regulations.
24
gross negligence. The manufacturer shall not be held liable for any damage arising
from such usage.
Only operate the charger in accordance with the degree of protection shown on the
rating plate.
Under no circumstances operate the charger if there is any evidence of damage.
Ensure that the cooling air can enter and exit unhindered through the air ducts on the
charger.
Arrange for the mains and charger supply to be checked regularly by a qualified elec-
trician to ensure the PE conductor is functioning properly.
Any safety devices and parts that are not functioning properly or are in imperfect con-
dition must be repaired by a qualified technician before switching on the charger.
Never bypass or disable protection devices.
After installation, a freely accessible mains plug is required.
Are only designed for use in industrial settings
Can cause line-bound and radiated interference in other areas
Satisfy the emissions criteria for residential and industrial areas. This is also true for
residential areas in which the energy is supplied from the public low-voltage mains.
Before switching on, always check the mains plug and cable as well as charger leads
and charging terminals for any signs of damage.
If the surface of the device housing is dirty, clean with a soft cloth and solvent-free
cleaning agent only