OHAUS Frontier FC5513 Bedienungsanleitung Seite 20

EN-14
- Volume pre-selection of sound signal
- Song selection of sound signal "end of run"
- Sleep Mode On / Off
The following operating data can be retrieved in this menu:
While the centrifuge is turned off, press simultaneously the keys "Time"(7) and "Stop/Lid" (9) and turn on the main
switch of the centrifuge. Now release both keys and as a result a display test is executed for approx. 5 seconds. All
indicators will appear at the same time (See figure 28).
ATTENTION:
Please notice that you must enter the program as described under point 4.1.2 to change the adjustments
of the points 4.1.3 - 4.1.8. After you have stored the settings you can change to
mode again by switching off the centrifuge for a short while.
All changed settings must be confirmed by the key "Start"(10). The word "Store" appears in the display
"RPM/RCF"(A-1) - Only then the pre-selections are valid!
-
Number of Starts
-
Operating Hours of Centrifuge
-
Operating Hours of Motor
-
Software Version
-
Error List
-
Function of the Imbalance Switch
-
Operation of Keyboard
-
Hardware Version
-
Intermediate Circuit Voltage in Volt
-
Display Tests
A-1
Figure. 28
Figure. 29
TM
Frontier Centrifuge FC5513
9
7
normal
10
2
program