ratiotec RS Serie Bedienungsanleitung Seite 10

Float function (only RS 1200)
After a cashing-up, a fixed sum is often left in the till as a float for the next day. This amount is inclu-
ded in the counting process, but it must be subtracted from the total sum. The Float sum is displayed
separately.
Activate the Float function
The Float Function is also located in the SETUP
menu and can be activated like the functions de-
scribed above. Float will appear on the display.
Use < or > to adjust the exact Float amount. Save
the desired amount by pressing OK.
To activate or inactivate the Float function after
setting the Float amount, press INFO for several
seconds (in the SETUP menu).
Note: To allocate the float total with the total
amount, press INFO for several seconds in the
normal counting mode. If the value is included in
the result, an arrow will be displayed next to the
word Float. Inactivate this function by pressing
INFO for several seconds.
Result without Float Result with Float
Carry out the Float function
If the Float Function is activated, the counting process starts with a negative value, which is the float
total previously chosen. The weighed coins and banknotes are added to the negative start value. The
money scale signalizes with a signal tone that the total reaches or exceeds a zero value.
Important Note:
If the Float function is activated, the functions Free weighing and Reference weighing are not available.
Please read the following information for further functions:
10