E600 Control Board; Technical Specifications; E600 Board Components; Terminal-Boards And Connectors - FAAC D600 Bedienungsanleitung

8 E600 CONTROL BOARD

8.1 Technical specifications

Supply voltage (V ~ / Hz.)
Power supply to accessories (Vdc)
Accessories max. load (mA.)
Operating ambient temperature (°C)
Quick-fit connector

Operating logics

Terminal-board connections
Courtesy light timer (min.)

8.2 E600 board components

J1 Low voltage inputs/accessories terminal board
J2 Quick-fit connector for receivers XF433 or XF868
J3 230V power supply input terminal board
J4 Connector for transformer primary winding
Courtesy light terminal-board
J5
J7 Connector for transformer secondary winding
J8 Motor output connector
J12 Battery module connector
Radio signal programming push-button
OPEN A
OPEN B Radio signal programming push-button
OPEN OPEN push-button
SETUP SET-UP push-button
Programming dip-switch
DS1
LD1 Signalling LED: OPEN input
LD2 Signalling LED: STOP input
LD3 Signalling LED: FSW input
Signalling LED: SET UP cycle
LD4
LD5 LED signalling memory-storage: radio channel OPEN A
LD6 LED signalling memory-storage: radio channel OPEN B

8.3 Terminal-boards and connectors

Description
Command device with N.O. contact
OPEN A
(see chap. OPERATING LOGICS)
Device with N.C. contact which stops the
STOP
automated system
Negative for OPEN A and STOP devices
Closing safety device with N.C. contact (see
FSW
chap. OPERATING LOGICS)
OPEN COLLECTOR 24 Vdc 100 mA. output for
LAMP
flashing lamp
Negative for powering safety accessories (FAIL
-TX FSW
SAFE function)
Negative for powering accessories
+24 Vdc for powering accessories

8.4 DS1 Programming dip-switches

No. Function
1 Fail Safe
2 Anti-crushing sensitivity
3 Not used
4 Carriage speed
230 / 50
24
200
-20 / +55
for receiver boards XF433 /
XF868 and battery module
Automatic / Semiautomatic
Open/Stop/Safety devices/Fail-
safe/Flashing lamp 24 Vdc
2
Connected device
OFF ON
Enabled Not enabled
Low High
/ /
High Low
LD1
LD2
LD3
J1
DS1
LD5
LD6
Fail Safe
If activated, it enables the photocell operating test before every
movement.
Operating logics
For doors with an irregular movement, it reduces the sensitivity of
the anti-crushing device to prevent unwanted action by it.
8.5 Operating logics
Logic A (automatic)
Status Open (pulse)
Opens and closes
CLOSED
after pause time
OPENING No effect
OPEN IN Resumes counting of
PAUSE pause time (1)
CLOSING Reverses motion
LOCKED Closes
Logic E (semi-automatic)
Status Open (pulse)
CLOSED Opens
OPENING Locks
OPEN Closes
CLOSING Reverses motion
LOCKED Closes
(1) Prevents closing if pulse is maintained.
(2) Prevents closing and/or opening if pulse is
maintained.
10
J8
LD4
J7
J2
J12
J4 J5
J3
Fig. 25
Stop Fsw
No effect (2) No effect
Locks (2) No effect (1)
Resumes counting of
Locks (1)
pause time (1)
Locks (2) Reverses motion
No effect (2) No effect (1)
Stop Fsw
No effect (2) No effect
Locks (2) No effect (1)
No effect (2) No effect (1)
Locks (2) Reverses motion
No effect (2) No effect (1)