Modify Params Menu; Modifying Parameters; Modifying Service Plans; Programming Clock Function - Atlas Copco CD65 Bedienungsanleitung

Modify params menu

Function
The menu allows the operator to program:
– Parameters.
– Protection settings.
– Service plan settings.
– Clock settings.
– Configuration settings.

Modifying parameters

Function
To modify a number of parameters.
Procedure
1. Starting from the Main screen:
– press the key "Menu" (F1)
~
– press the key until the option "Modify params" is followed by
a horizontal arrow
– press the tabulator key to activate the menu
2. The first option ("Parameters") will be followed by a horizontal
arrow.
3. Press the tabulator key: the first item ("PDP level") and its setting
will appear.
~
4. Use the key to scroll until the parameter to be modified is
followed by a horizontal arrow.

Modifying service plans

Function
To modify the hour intervals for the Service plans.
Service plans
The service operations to be carried out are grouped in plans, called
Service plan A, B or C. When reaching an interval, a message will
appear on the screen indicating which Service plans are to be carried
out.
!
Always consult Atlas Copco in case any timer setting should
be changed. The intervals must not exceed the periods
below and must coincide logically.
2904 0177 04

Programming Clock function

To program time-based start/stop commands for the dryer.
Programming start/stop commands
In this example, the dryer will be programmed as follows:
– On Monday at 06:15 starting
– On Saturday at 18:00 stopping
1. Starting from the Main screen:
– press the key "Menu" (F1)
~
– press the key until the option "Modify params" is followed by
a horizontal arrow
– press the tabulator key to activate the menu
~
2. Use the key to scroll until the option "Clock function" is followed
by a horizontal arrow. Press the tabulator key, following screen
appears:
Clock Function
Not activated
Menu Mod
F1 F2
3. Press the tabulator key, following screen appears:
Monday
Tuesday
Wednesday
Menu Mod
F1 F2
| ~
4. Use the or key until the day on which a command must be
programmed is followed by a right pointing arrow. Press the
tabulator key, following screen appears:
- - : - - - - - - - - - - - - -
- - : - - - - - - - - - - - - -
- - : - - - - - - - - - - - - -
Menu Mod
F1 F2
5. Press the key "Mod" (F2). The first two dashes will flash. Use the
| ~
or key to enter "06". Press the tabulator key to jump to the
following two dashes. Use the
tabulator key to jump to the row of dashes. Use the
enter the command Start. Press the key "Prog" to program the
command: 06:15 Start
6. Programming the command to stop on Saturday at 18:00 is
carried out in a similar way as described above.
I
NSTRUCTION MANUAL
}
Del
F3
}
~
Del
F3
}
~
Del
F3
| ~
or key to enter "15". Press the
| ~
or key to
7