Check The Operation Of The Loaded Camera; Confirm The Camera Mode; Perform The Final Checks; Visual Inspection - Olympus PT-E03 Bedienungsanleitung

Check the operation of the loaded camera.

After sealing the Case, check that the camera functions normally.
• Operate the power switch lever on the Case and confirm that the camera can be turned ON/OFF.
• Turn the mode dial knob on the Case and confirm that the camera mode switches properly.
• Operate the shutter lever on the Case and confirm that the camera shutter is released.
• Operate the zoom dial on the Case and confirm that the camera's lens is controlled.
• Operate other control buttons on the Case and confirm that the camera functions properly as intended.
CAUTION:
• If the camera does not function properly, remove the camera and reload it, starting from "Check the digital
camera." (P. 16) of this manual.
• After loading the camera in the Case, confirm that the Case's mode dial can be rotated.
If not, the Case's mode dial may not be positioned properly on the camera's mode dial. Set the mode dials
properly.

Confirm the camera mode.

Confirm the camera mode by looking at the
camera's mode dial through the mode check
window at the top of the Case.

Perform the final checks.

Visual Inspection

After closing the case tightly, check the seal between the front and rear lids and the connection between
the port and case to make sure the O-rings are not twisted, that they sit properly in the grooves, and that
no foreign matter has been caught between the two parts.
CAUTION:
Hair, fiber, and other narrow items are not very apparent, but they may cause entry of water, therefore special
attention is required.
Mode check window
En
EN 26