4
Connect the necessary cable(s)
to the TV.
Make sure to connect the cables before
installing the TV on the wall. You will be
unable to connect the cables when the TV
is installed.
Note
Subcontract the cable routing in the wall to a licensed
contractor.
Bundle the connecting cables to prevent stepping on
them before wall mounting.
5
Detach the Table-Top Stand
from the TV.
Note
Be careful when lifting the TV as the Table-Top Stand
is detached, the Table-Top Stand may topple over
and cause personal injury.
Take care when removing the Table-Top Stand from
the TV to prevent it from falling over and damaging
the surface that the TV is sitting on.
Be sure to store the removed screws and unused
parts in a safe place, keeping them away from
children.
KD-49XH95xx,
KE-49XH95xx
1
Remove the screws from the
rear of the TV.
Note
Be sure to store the removed screws and unused
parts in a safe place, keeping them away from
children.
2
Attach the Attachment parts for
Wall-Mount Bracket. Check the
Attachment parts by referring to
"Supplied with SU-WL450" in
"Checking the parts" on page
6.
Note
Firmly secure the Attachment parts using screws.
When using an electric screwdriver, set the torque
setting to approximately 1.5 N·m {15 kgf·cm}.
Standard mounting (2-a)
Belt
Slim mounting (2-b)
Belt
3
Connect the necessary cable(s)
to the TV.
Make sure to connect the cables before
installing the TV on the wall. You will be
unable to connect the cables when the TV
is installed.
Note
Subcontract the cable routing in the wall to a licensed
contractor.
Bundle the connecting cables to prevent stepping on
them before wall mounting.
− 12 (GB) −
Pulley
Screw
(+PSW 6 x 20)
Spacer
(60 mm)
Screw (+PSW 6 x 50)
Pulley
Spacer (20 mm)
Screw (+PSW 6 x 20)