Specifications; Ec Declaration Of Conformity - Makita 6842 Bedienungsanleitung

ENGLISH
1-1. Lock button
1-2. Switch trigger
2-1. Reversing switch lever
3-1. Hook
3-2. Clamping screw
4-1. Casing
4-2. Thumb screw
5-1. Plane bearing
5-2. Dust cover
5-3. Bit

SPECIFICATIONS

No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For Model 6842, 6843
For European countries only
Noise
The typical A-weighted noise level determined according
to 60745-2-2:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 85 dB (A).
Wear ear protection.
Vibration
The vibration total
determined according to EN60745-2-2:
Work mode: screwdriving without impact
Vibration emission (a
Explanation of general view
6-1. Lever
6-2. Stopper base
6-3. Label on feeder box
6-4. Fenestella
7-1. Stopper base
7-2. Casing
7-3. Adjusting knob
8-1. Feeder box
8-2. Screw strip
8-3. Screw guide
Model
Screw strip
-1
)
Overall length
Net weight
Safety class
) : 84 dB(A)
pA
value (tri-axial vector
2
) : 2.5 m/s or less
h
6842
4 mm x 25 mm - 55 mm
4,700
ENE033-1
For Model 6844
For European countries only
Noise
ENF002-1
The typical A-weighted noise level determined according
to 60745-2-2:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 85 dB (A).
Vibration
The vibration
determined according to EN60745-2-2:
Work mode: screwdriving without impact
ENG101-1
Vibration emission (a
EC-DECLARATION OF CONFORMITY
Model; 6842, 6843, 6844
We declare under our sole responsibility that this
product is in compliance with the following standards of
standardized documents;
EN60745, EN55014, EN61000 in accordance with
Council Directives, 2004/108/EC, 98/37/EC.
ENG204-1
sum)
000230
Responsible Manufacturer:
Makita Corporation
3-11-8, Sumiyoshi-cho, Anjo, Aichi, JAPAN
4
9-1. Driving position
11-1. Reverse button
13-1. Extension handle
15-1. Wall
15-2. Stopper base
16-1. Limit mark
17-1. Brush holder cap
17-2. Screwdriver
6843
6,000
400 mm
2.0 kg
/II
) : 85 dB(A)
pA
Wear ear protection.
total value (tri-axial
) : 2.5 m/s
h
CE2006
Tomoyasu Kato
Director
6844
4 mm x 45 mm - 75 mm
3,000
440 mm
2.1 kg
ENG101-1
ENG204-1
vector sum)
2
or less
ENH101-7