Hydro-Pro INVERBOOST+ Tech Benutzer- Und Wartungshandbuch Seite 25

Notice : During the parameter checking and setting, press the
Press again to turn on/off the machine.
6.2.2 button
Automatic mode:
Press for 5 seconds to switch to automatic mode.(default:Smart mode)
Press for 5 seconds again to exit automatic mode and switch to heating mode(default:Smart mode)
Note:Under Automatic mode, it is useless to set parameter P1 .
Operation logic of Auto Mode:
Set water temperature
(Tset)
℃
Tset (eg: 28 )
℃
Tset (eg: 28 )
6.2.3 and
Clock/unclock the display:
Hold and
Water temperature setting :
or
Press
Parameter checking :
Press first, then press
Code
d0
d1
d2
d3
d4
d5
Current water in
temperature
℃
(Tset +2 )
℃ ℃
Tset +2 (eg:30 )
℃ ℃
Tset-2 (eg: 26 )
button
for 5 seconds to lock/Unlock the display.
to set the water temperature directly.
to check the " User parameter from d0 to d11
Condition
IPM mould temperature
Inlet water temp.
Outlet water temp.
Ambient temp.
Frequency limitation code
Piping temp.
to quick-exit and save the current setting .
Current working
mode
Heating mode
Cooling mode
Scope
0-120℃
-9℃～99℃
-9℃～99℃
-30℃～70℃
0,1,2,4,8,16
-30℃～70℃
23
After 3 minutes or
above, it will switch to
Cooling mode
Heating mode
Remark
Real testing value
Real testing value
Real testing value
Real testing value
Real testing value
Real testing value