Inhaltsverzeichnis
Werbung
Switching off functions
1. Press setup" button 8 until the
required special function is selected.
2. Press the selection and acknowledge
ment button 11 -" until the selection
is no longer enclosed in a frame and
is therefore switched off.
Note ambient
temperature and
ventilation
The climatic class can be found on the
rating plate. It specifies the ambient
temperatures at which the appliance may
be operated. The rating plate is located at
the bottom left-hand side inside the
fridge.
Climatic category
SN
N
ST
T
Ventilation
Fig. 3
The air at the back of the appliance will
heat up. This warm air must be allowed to
freely escape, otherwise the refrigerating
machine must perform more. This raises
electricity consumption. Hence, the
air inlet and outlet apertures should never
be covered or blocked off!
Permitted ambient
temperature
+10 °C to 32 °C
+16 °C to 32 °C
+16 °C to 38 °C
+16 °C to 43 °C
Connecting
the appliance
After installing the appliance, wait at least
1 hour until the appliance starts up.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for
the first time, clean the interior of the
appliance (see chapter Cleaning).
The socket should be freely accessible.
Connect the appliance only to
220 240 V/50 Hz alternating current via
a correctly installed earthed socket.
The socket must be fused with a 10 A
to 16 A fuse.
If the appliance is to be operated in
a non European country, check on
the rating plate whether the indicated
voltage and current type correspond
to the values of your mains supply.
The rating plate is situated in the bottom
left hand side of the appliance. The power
cord may be replaced by a technician
only.
Warning
!
Never connect the appliance to electronic
energy saver plugs or to power inverters
which convert the direct current to 230 V
alternating current (e.g. solar equipment,
power supplies on ships).
en
27
Werbung
Inhaltsverzeichnis
