Charging - Silvercrest SFR 37 B1 Bedienungsanleitung

*%B*5$ B+HUUHQUDVLHUHUIP 6HLWH  'LHQVWDJ  0DL    

5. Charging

NOTES:
• Charge the battery for at least 2 hours before using the device
for the first time. After that, a charging time of 90|minutes is
sufficient.
• In order to increase the service life of the battery, we recom-
mend ...
... to use the device regularly and without long storage
times,
... to discharge the battery prior to the charging procedure
(00%|7 is shown, plug symbol|9 flashes red).
• The capacity/charging state of the battery|7 is displayed in
percent (00, 10, ... ,100% in increments of ten).
• When the batteries are almost empty, the plug symbol|9
flashes in red. The device can then only be used for a short
time without being connected to the electricity supply.
• It takes about 5 minutes to charge the device sufficiently for
one shave.
• When the battery is fully charged, the device can be used
for approximately 90 minutes without being connected to the
power supply.
1. Switch off the device with the on/off switch|6 if necessary.
2. Connect the plug-in power unit|17 to the socket|11 on the
device.
3. Insert the plug-in power unit|17 in into an easily accessible wall
socket, the voltage of which corresponds to the rating plate.
4. The charging indicator|8 flashes and the battery is charged.
When the battery is fully charged, 100% is shown and the
charging indicator|8 is lit.
88
GB