Herunterladen Inhalt Inhalt Diese Seite drucken
Vorschau ausblenden Andere Handbücher für Hei-TORQUE Core:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Assembly

Shaft guard


Installing the shaft guard (optional accessory)
A shaft guard can be fitted to the laboratory stirrer to protect against injuries caused by
the rotating shaft (see chapter "Spare parts and accessories, accessories").
Warning:
Risk of injury!
If the device is switched on when installing the shaft guard, it is
possible for the device to rotate due to unintentionally touching the
control knob or the high-speed button and this could result in injuries.
Only install the shaft guard when the device is switched off.
Scope of delivery:
▪ 1 Two piece shaft guard
▪ 2 Knurled screws
➜ Insert both knurled screws into the
holes above the chuck and tighten
them by two or three turns.
➜ Slide the two grooves on the shaft
guard over the threads of the screws
and then turn the shaft guard to the
right until the end of the groove.
➜ Carefully tighten both of the knurled
screws.
Dismantling the shaft guard
➜ Loosen both knurled screws by one or two turns.
➜ Turn the shaft guard to the left and remove it from the stirrer in a downwards
direction.
Shaft guard
Knurled screws
Shaft guard
26
Knurled screws

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis