Support Rod And Chuck; Mounting The Support Rod; Dismantling The Chuck - Heidolph Hei-TORQUE Core Bedienungsanleitung

Assembly

Support rod and chuck



Mounting the support rod

The support rod is used to mount the
overhead stirrer onto e.g. a stand or
lattice.
Scope of delivery:
▪ Support rod
▪ Allen key
There is a drilled hole on the rear of the
device for inserting the support rod.
➜ Push the support rod with the notch
at the front as far as it will go into the
hole on the rear of the device.
➜ Ensure that the notch on the support
rod is located in front of the grub
screw on the housing.
➜ Fix the support rod in place by
tightening the grub screw with the aid
of the supplied Allen key.

Dismantling the chuck

➜ Remove any impeller that is clamped
in the chuck.
➜ Loosen the grub screw for the
clamping ring with the aid of the
supplied Allen key.
➜ Pull the chuck downwards and away
from the hollow shaft.
➜ When installing the chuck again,
ensure that the grub screw has been
aligned with the recess on the hollow
shaft.
Support rod
Allen key
Notch
Grub screw
Allen key
Grub screw
Allen key
Recess for grub
screw
Grub screw
25
Notch