Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting; Malfunctions And Troubleshooting - Heidolph Hei-TORQUE Core Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für Hei-TORQUE Core:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Troubleshooting

Malfunctions and troubleshooting


Error
Chuck cannot be
correctly closed,
clicking noise when
closing
Rotation stops;
Error message:
"Error: Overload"
Error message:
"Error: Overheating"
Display remains dark
after switching on
The chuck can become overwound if it is opened with excessive force.
The overwinding issue has been resolved when you can no longer hear
any clicks when closing the chuck.
If you experience a malfunction that cannot be resolved using the information listed
above, please immediately inform your authorized Heidolph dealer.
Troubleshooting
Possible cause
Chuck was opened with
too much force and has
been overwound
▪ Load too high
▪ Impeller blocked
Motor or electronics
too hot: Overheat
protection activated
No power supply
Remedy
▪ Hold the clamping ring and open the
chuck until after a slight resistance
you hear one or more clicks
▪ Close the chuck again
(also see the information below)
▪ Remove the cause of the blockage
(viscosity of the medium may be too
high)
▪ Re-start the rotation
▪ Switch off the device
▪ Allow the motor to cool down and
switch the device on again
Check that the power cord plug is
connected properly to the power socket
and the device
23

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis