Troubleshooting; Error Codes - ECG EDF 6023 WA++ Bedienungsanleitung

remove the hose from the tap. Remove the filter and rinse it under running water. Put the clean filter in its place
and screw the hose back onto the tap.
How to keep your dishwasher in good condition
After each washing
After each wash, close the water supply to the
appliance and leave the door slightly open so that the
moisture and odors can vent from the interior.
Disconnect the power supply
Before any cleaning and maintenance disconnect the
power supply. Do not take a risk.
Do not use solvents or abrasive cleaners
Never use solvents or abrasive cleaners to clean the
exterior and rubber parts of the dishwasher. Use
only cloth dipped into warm, soapy water. Remove
stains and residue from the interior surfaces of the
dishwasher with a cloth soaked in a mild vinegar
solution or a special agent intended for dishwashers.
During vacations

TROUBLESHOOTING

Error codes

Individual error codes are displayed using the front panel indicators. The commendations in the following
table may help you solve the problem. If the problem persists, contact an authorized service center.
Error code
Wash Exit Start/Pause
18
If the appliance will not be in use for longer time,
perform a wash cycle without dishes, disconnect the
power supply, close the water supply and leave the
door of the dishwasher ajar. This will prevent forming
odors inside the appliance and you will save the door
seal.
Moving the dishwasher
If the machine must be moved, try to transport it in an
upright position. If it is absolutely necessary, it can be
placed on its back.
Seal
Remains of food that gets stuck in the door seals are
one of the factors creating the odor in the dishwasher.
Prevent the formation of odor by regularly cleaning
the seal with a damp sponge.
Error description
Insufficient water supply.
Error in the continuous supply
of water.
Can not drain the waste water.
The required water temperature
cannot be reached. Faulty
heating element or temperature
sensor.
The overflow alarm was
activated.
Faulty electronic card.
Solution
• Make sure that the water tap is completely open.
• Turn off the tap, disconnect the hose from the inlet and
clean the inlet hose filter.
• Restart the dishwasher and if the problem persists, contact
the service.
• Close the water supply.
• Contact the service.
• The drain hose is clogged.
• The dishwasher filters might be clogged.
• Turn the dishwasher on and off and cancel the washing
program.
• If problems persist, contact the service.
• Contact the service.
• Switch off the dishwasher and close the water supply.
• Contact the service.
• Contact the service.