Getting Ready For Operation - Gastroback Vital Mixer Plus Bedienungsanleitung

To avoid damage
Do not overfill the jar. Do not expose the jar to extreme temperature variations.
Leave hot food cool down sufficiently (lukewarm), before filling the jar. To avoid
overheating, do not operate the motor continuously for more than 2 minutes. Allow
the motor to rest for at least 1 minute before continuing. If the blades get stuck or agi-
tate noticeably slow, stop operation immediately (rotary switch to "0") and unplug.
Then add some liquid, remove any obstacles, and/or take out some food. Do not
run the appliance with the jar empty or with the contents completely dry (e.g. nuts
or cereals).
Do not place the jar on inclined or uneven surfaces or at the edge of the table or
counter. Otherwise it could fall over or fall down. Keep in mind that the jar is very
heavy, especially when it is filled up.

GETTING READY FOR OPERATION

1. Prepare your food. Remove all inedible parts and cut your food to pieces of
approx. 2 - 3 cm in size.
2. Place the motor base on a suitable surface near a suitable wall power outlet (see:
'General Safety Instructions' and 'Important Safeguards for Electrical Appliances').
Ensure that all parts are in proper working order and clean. If required, assemble
the jar (see: 'Care and Cleaning / After Cleaning—Reassembling the Jar').
WARNING
– the bottom of the jar is completely leak-free. The exterior is dry and clean.
– the appliance is switched OFF (rotary switch to "0"). Add a sufficient amount
of ingredients to the jar. At the maximum, fill to the "6 CUPS" / "1.5 Litre" filling
line with liquids. When processing very glutinous or solid food (e.g. vegetables),
do not fill in more than 600 g. If you wish to process larger amounts, divide your
food to portions accordingly.
3. Close the jar with the lid and press the lid gently down for engaging the handle
of the lid at the handle of the jar with a click. Insert the measuring cup upside
down into the central opening of the lid.
4. Turn the rotary switch to "0". Ensure that the jar is completely leak-free with
the exterior dry and clean. Place the jar onto the motor base. The jar must stand
firmly in straight upright position, with the handle of the jar facing to the right
side of the motor base. The appliance is ready for operation now.
– Before placing the jar onto the motor base, always ensure ...
EN
47