Operating Determinations - EuroLite 4/5P Bedienungsanleitung

This device falls under protection-class I. The power plug must only be plugged into a protection class I
outlet.
Always plug in the power plug least. Make sure that the power-switch is set to OFF position before you
connect the device to the mains.
Never let the power-cord come into contact with other cables! Handle the power-cord and all connections
with the mains with particular caution!
Make sure that the available voltage is not higher than stated on the rear panel.
Make sure that the power-cord is never crimped or damaged by sharp edges. Check the device and the
power-cord from time to time.
Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the
power-cord by the plug. Never pull out the plug by tugging the power-cord.
Please consider that damages caused by manual modifications to the device are not subject to warranty.
Keep away children and amateurs!

OPERATING DETERMINATIONS

This device is a lighting controller for controlling Ropelights. This product is allowed to be operated with an
alternating current of 230 V, 50 Hz and was designed for indoor use only.
The device must only be connected with Ropelights with 5-pin plug.
Do not shake the device. Avoid brute force when installing or operating the device.
When choosing the installation-spot, please make sure that the device is not exposed to extreme heat,
moisture or dust. There should not be any cables lying around. You endanger your own and the safety of
others!
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.
CONNECTIONS
Sound input
The sound signal is picked up via the integrated condensor microphone. This is why not extra connection to
the sound source is necessary.
Mains input
Plug the power-plug into your safety socket.
The occupation of the 3-core lead (3 x 1.5 mm²) is as follows.
Brown
Blue
Green/Yellow
The ROPELIGHT CONTROLLER 4/5P must be earthed.
live
neutral
earth
7