Abicor Binzel ABIROB A Betriebsanleitung Seite 32

6 Putting into operation
6.2 Setting up the cable assembly
1
8
1 Connection module
2 Emergency stop cable
3 Control lead
Fig. 5 Setting up the cable assembly
NOTICE
• Select the correct wire type and appropriate wire guide for your application.
• For information on cutting the wire guide to size and correctly assembling it, please see
the following section:
 9 Maintenance and cleaning on page EN-16
• Spiral liners = for steel and stainless steels
• PA liners = for aluminum, copper, nickel and stainless steels
1 Lay out the cable assembly (7) straight and attach it to the connection module (1) on the
torch side.
2 Slide the cut-to-length wire guide from the central connector (4) up to the stop in the contact
tip and screw into place with the connection nut (6).
If required, connect the emergency stop cable (2) of the CAT robot mount (8) to the cable
assembly (7).
 6.4 Connecting the control lead on page EN-13
EN - 12
2
7
4 Central connector
5 Air-blast hose
6 Connection nut
ABIROB
7 Cable assembly
8 CAT robot mount
BAL.0125 • 2019-04-15
®
A
3
4
5
6