Abicor Binzel ABIROB A Betriebsanleitung Seite 31

®
ABIROB A
6.1 Setting up the
1 2
8
1 Gas nozzle
2 Contact tip
3 Tip adaptor
Fig. 4 Setting up the ABIROB
1 Screw the replaceable tip adaptor (3) into the torch neck (4) and tighten using the switch
key wrench (8).
2 Screw the contact tip (2) into the tip adaptor (3) and tighten using the switch key
wrench (8).
3 Screw the gas nozzle (1) onto the tip adaptor (3) hand tight.
4 Insert the torch neck (4) into the connection module (5) until reaching the stop.
5 Use the Allen key (6) to tighten the set screws (7).
BAL.0125 • 2019-04-15
®
A torch neck
ABIROB
3 4
4 Torch neck
5 Connection module
6 2 x set screw M5
®
A torch neck
7
7 AF 2.5 mm Allen key
8 Switch key wrench
6 Putting into operation
5
6
EN - 11