For Stranded Wiring; Examples Of Shield Wires - Panasonic S-15MM1E5A Installationsanleitung

How to connect wiring to the terminal

■ For stranded wiring

(1) Cut the wire end with cutting pliers,
then strip the insulation to expose
the stranded wiring about 10 mm and
tightly twist the wire ends. (Fig. 4-7)
(2) Using a Phillips head screwdriver,
remove the terminal screw(s) on the
terminal board.
(3) Using a ring connector fastener or
pliers, securely clamp each stripped
wire end with a ring pressure terminal.
(4) Place the ring pressure terminal,
and replace and tighten the removed
terminal screw using a screwdriver.
(Fig. 4-8)

■ Examples of shield wires

(1) Remove cable coat not to scratch braided shield. (Fig. 4-9)
(2) Unbraid the braided shield carefully and twist the
unbraided shield wires tightly together. Insulate the shield
wires by covering them with an insulation tube or wrapping
insulation tape around them. (Fig. 4-10)
(3) Remove coat of signal wire. (Fig. 4-11)
(4) Attach ring pressure terminals to the signal wires and the
shield wires insulated in Step (2). (Fig. 4-12)
■ Wiring samples
Type M1
Clamper inside the box for
Remote Control Wiring and
Inter-unit Control Wiring
Use this screw when connecting
the shield for the Inter-unit control
wiring to ground.
Functional ground screw (External Electronic
Expansion Valve Kit and Schedule Timer)
Stranded wire
Ring
pressure
terminal
Fig. 4-7
Inter-unit Control Wiring
Remote Control Wiring
Clamping Clip
Clamper on the front
side for Power Supply
Protective ground screw (External
Solenoid Valve Kit for 3WAY)
Special
Screw
washer
Ring pressure
terminal
Terminal board
Wire
Fig. 4-9
Insulation tape
Fig. 4-10
Insulation tape
Fig. 4-11
Fig. 4-12
Inter-unit Control Wiring
Wire Saddle
Power Supply
Wire Saddle
Power Supply
* Route the power supply cord through the ring of
the supplied wire saddle and clamp the cord.
15
Screw and
Special washer
Ring
pressure
terminal
Wire
Fig. 4-8
Shield mesh
Shield mesh
Remote Control Wiring
Supplied Clamper *