Technical Specifications - Cosmo CLASSIC Installations-, Bedienungs- Und Gebrauchsanweisung

The regulation setpoint is then 7°C (not displayed)
If window close detection, then the system gets back to the previous mode (comfort
mode, clock mode, forced mode, or others)
b) If press Standby : go to standby mode (with buzzer sound)
c) If press any other buttons: cancel the window open and the system gets back
to previous mode (comfort mode, clock mode, forced mode, or others).
Note: The open window detection works only when the room temperature is stable (visualized by decimal dot blinking). If the
room temperature is not stable then the open window detection function does not work.
APPENDIX: STABLE TEMPERATURE
"Stability" means: temperature variation at the controller sensor is now stable enough
in order for the unit to distinguish a temperature variation coming from regulation
process (normal variation) from a temperature variation created by the event "window
open" (abnormal variation)
Example of instability cases:
- When you power up the towel heater, it takes time until the setpoint is reached.
- When you change the setpoint, then it takes time until you reach the new setpoint.
Operating voltage
Maximum el. input
Insulation class
Protection rating
Operating temperature
Storage temperature
Operating humidity
Maximum altitude above sea level
Temperature control
Temperature setting range
Note: Default embedded settings for temperature regulation are based on standard radiator and environment.
Snow symbol blinking when window open status is detected

TECHNICAL SPECIFICATIONS

230 V ±10% AC 50 Hz
2000 W
Class I
IPX4
0 ÷ 50 °C
-20 ÷ 70 °C
0 ÷ 85% at 25 °C (without condensation)
2000 m
Buttons +/-
7 °C, 15–30 °C
12