Steam Ironing; Dry Ironing - Vitek VT-1241 GY Die Betriebsanweisung

perature is set, the light indicator (10)
will go out. If the temperature goes below
the set level the indicator (10) will light
up again.
Water spray
• You can dampen the fabric by press-
ing the spray button (5) several times
(pic. 3).
• Make sure that there is enough water in
the water tank.

STEAM IRONING

The iron is provided with anti-drip valve
that stops water supply, if the soleplate
temperature is too low, it prevents dripping
from the soleplate openings.
• Steam ironing is possible only at high
temperature of the iron soleplate (tem-
perature control knob (4) positions: «••»
or «•••»).
• Insert the plug into the socket.
• Place the iron on its base (9).
• Set the required ironing temperature
using the temperature control knob (4):
«••» or «•••».
• Make sure that there is enough water in
the water tank.
• Wait till the light indicator (10) goes out
and then lights up again. Set the contin-
uous steam supply knob (3) to the right-
most position - continuous steam supply
is on (pic. 4), the steam will go out of the
soleplate (12) openings.
ATTENTION!
If steam is not supplied constantly during
the operation, check whether the tempera-
ture control (4) is set properly.
BURST OF STEAM
Burst of steam function is useful when
ironing of folds and can only be used at
high ironing temperatures (when the iron
temperature control knob (4) is set to «•••»
position).
VT-1241_IM.indd 7
• Set the temperature control knob (4) to
the position «•••».
• When pressing the burst of steam button
(6) steam will go out of the iron soleplate
more intensively (pic. 5).
Note:
In order to avoid water leakage from steam
openings, press the burst of steam button
(6) with a 4-5 sec. interval.
Vertical steam
Insert the plug into the socket.
• Place the iron on its base (9).
• Set the temperature control knob (4) to
the position «•••».
• Make sure that there is enough water in
the water tank.
• Wait till the light indicator (10) goes out
and then lights up again.
• Hold the iron vertically and press the
burst of steam button (6), steam will be
supplied from the soleplate (12) inten-
sively (pic. 6).
Important information
• Vertical steam is not recommended for
synthetic fabrics.
• To avoid fabric burning, do not touch it
with iron soleplate while steaming.
• Never steam clothes on a person as the
steam temperature is very high and may
cause burns, use clothes hanger or a
stand.

DRY IRONING

• Insert the plug into the socket.
• Place the iron on its base (9).
• Set the continuous steam supply knob
(3) to the leftmost position - continuous
steam supply is off.
• Set the required ironing temperature
with the temperature control knob (4):
«•», «••» or «•••».
• Wait till the light indicator (10) goes out
and then lights up again - the iron sole-
plate reached the required temperature
and you can start ironing.
7
ENGLISH
09.10.2013 16:38:54