Twisting Hair Strands Into A Braid; Incorporating Hair Ornaments - Silvercrest SHTB 3 B1 Bedienungsanleitung

7) Once your strands have been twisted over their entire length, release gripper
button I
NOTE
► Ensure that you do not overtwist your hair strands. The hair could become
knotted at the ends.

Twisting hair strands into a braid

1) Press rotator button II
and the two hair strands are twisted around each other.
2) Once the two hair strands have been twisted completely around each other,
release rotator button II
NOTE
► Depending on your requirements, you can twist your hair strands tightly or
loosely together by keeping rotator button II
or longer time. Here too, ensure that you do not overtwist your hair strands.
3) Remove the hair strands from the grippers
the sliders
4) Tie off the braid with a hair tie. You can find more hair ties in any well-stocked
drugstore or hairdressing suppliers

Incorporating hair ornaments

You can incorporate hair ornaments such as satin ribbons, pearl ribbons or other
decorative ribbons in your braids. Decorative ribbons are available from craft
supply stores.
1) Separate two hair strands from your hair and comb them thoroughly.
2) Knot the required decorative ribbon into the beginning of the braid.
3) Press one of the sliders
4) Place the end of the hair strand and the decorative ribbon in the gripper
and release the slider
■ 32 │ GB │ MT
.
and keep it pressed down. The rotator
.
.
for raising the gripper
again.
pressed down for a shorter
, by raising the gripper
upwards.
SHTB 3 B1
rotates
with