Silvercrest SFA 4.1 E1 Bedienungs- Und Sicherheitshinweise Seite 16

SilverCrest SFA 4.1 E1
If pairing has already taken place, hold the standby button (8) down for about eight seconds when the hands-free kit
is switched off. After about three seconds, buttons 3, 4, 5 and 8 will flash blue and you will hear a series of beeps.
After about five more seconds, you will hear a beep and the mute button (3) will flash alternately orange and blue.
®
The hands-free kit is now in pairing mode. Activate the Bluetooth function of your mobile phone and let it search for
®
Bluetooth devices nearby. To do so, refer to your mobile phone manual. From the list of devices detected, select
device 'SFA 4.1 E1'.
Enter '0000' if you are asked for a PIN during the pairing process.
The name of the hands-free kit 'SFA 4.1 E1' will now appear in the list of devices connected to your mobile phone. A
beep indicates that pairing was successful. The hands-free kit is now in standby mode and buttons 3, 4, 5 and 8 flash
blue briefly once at regular intervals of about ten seconds. The device goes into search/pairing mode as soon as the
connection is severed.
If the connection to the smartphone is interrupted, the hands-free kit goes into search/pairing mode for about one
minute. A beep is emitted after the end of this time. After approximately 20 more seconds, buttons 3, 4, 5 and 8 flash
blue four times and the hands-free kit automatically switches to energy saving mode. The hands-free kit is fitted with a
shock sensor. As soon as the hands-free kit detects a shock, for example when closing the car door, it switches
automatically from energy saving mode back to standby mode (BT connection is reactivated).
You can pair or connect other devices to the hands-free kit in a similar manner. The pairing begins for each device with
the hands-free kit switched off as described above.
14 - English