Specifications - Makita 5008MG Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Depth guide
1-2. Lever
2-1. Lever
2-2. Positive stopper
2-3. Arrow on positive stopper
3-1. Base
4-1. Switch trigger
5-1. Lamp
6-1. Hex wrench
6-2. Protrusion

SPECIFICATIONS

Max. Cutting depth
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for performing lengthways and
crossways straight cuts and mitre cuts with angles in
wood while in firm contact with the workpiece.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects
to the operation of other equipment. With a mains
impedance equal or less than 0.37 Ohms it can be
presumed that there will be no negative effects. The
mains socket used for this device must be protected with
a fuse or protective circuit breaker having slow tripping
characteristics.
Noise
The typical A-weighted noise level determined according
to EN60745:
Explanation of general view
7-1. Hex wrench
7-2. Shaft lock
8-1. Saw blade
8-2. Hex bolt
8-3. Outer flange
8-4. Inner flange
8-5. Ring
9-1. Vacuum cleaner
10-1. Rear handle
10-2. Front grip
Model
Blade diameter
at 90°
at 45°
at 50°
-1
)
Overall length
Net weight
Safety class
ENE028-1
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
ENF002-2
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode : cutting wood
ENF100-1
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
ENG905-1
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
3
10-3. Base
11-1. Rip fence (Guide rule)
12-1. Base
12-2. Adjusting screw
13-1. Triangular rule
14-1. Limit mark
15-1. Brush holder cap
15-2. Screwdriver
5008MG
210 mm
75.5 mm
57 mm
51.5 mm
5,200
332 mm
5.1 kg
/II
) : 95 dB(A)
pA
) : 106 dB(A)
WA
Wear ear protection
2
) : 3.0 m/s
h,W
2
ENG900-1
ENG901-1