Important Safety Instructions - Concept VZ 1400 Bedienungsanleitung

ACKNOWLEDGMENT
Thank you for purchasing a Concept product. We hope you will be satisfied with our product throughout its
service life.
Please study the entire Operating Manual carefully before you start using the product. Keep the manual in a safe
place for future reference. Make sure other people using the product are familiar with these instructions.
Voltage
Input
Operating temperature

IMPORTANT SAFETY INSTRUCTIONS

• Use the unit only as described in this operating manual.
• Remove all the packaging and marketing materials from the unit before the first use.
• Make sure the mains voltage corresponds to the values on the rating plate.
• For further protection, it is recommended to install a current protector (RCD) with the actuating current
not exceeding 30 mA in the power circuit of the bathroom. Please consult an electrician.
• The unit reaches high temperatures during operation and remains hot for some time after being turned
off. Do not touch the hot surfaces. Use the handles and buttons. There is a risk of being burned.
• The unit may not be cleaned, stored, or covered until it has cooled down completely.
• Do not leave the unit unattended while it is turned on or even only plugged into the wall outlet.
• If you need to lay the unit aside during use, always switch it off and lay it on a fireproof surface.
• Before plugging in or unplugging the unit from the wall outlet, make sure the switch is OFF.
• When disconnecting the unit from the wall outlet, never pull the power cord. Grasp the plug and
disconnect it by pulling.
• Do not allow children or unskilled people to handle the unit. Use the unit out of the reach of these
individuals.
• Persons with limited movement capacity, reduced sensory perception, insufficient mental capacity or
those who are unaware of the proper handling should use the product only under the supervision of
a responsible, aware person.
• Take extra care when using the unit near children.
• Don't let anyone use the unit as a toy.
• Turn the unit off, unplug the power cord from the wall outlet, and let the unit cool before cleaning
and after use.
• Make sure the power cord does not touch hot surfaces.
• Do not let the unit hang loosely on the power cord.
• Do not use the unit in an environment with explosive gases or flammable substances (solvents, varnishes,
adhesives, etc.).
• Do not use hairspray or other spray products when the unit is in use.
• Do not use flammable substances such as hairspray, setting lotion etc., as they may ignite when they come
into contact with the straightener plates.
• Do not use abrasive or chemically aggressive substances for cleaning the unit.
• Do not use the unit if it does not operate properly, or if it has been dropped, damaged or exposed to any
liquids. Refer the unit to an authorized service center for testing and repair.
• Never use an appliance with a damaged power cord or plug. Contact an authorized service center
immediately
VZ 1400
Technical parameters
220–240 – 50 Hz
120°C 140°C 160°C 180°C 200°C
35 W
EN
23