Setting The Daylight Level; Orientating The Motion Detector; Cleaning And Storage; Troubleshooting - LIVARNOLUX IAN 300304 Montage-, Bedienungs- Und Sicherheitshinweise

Setting the daylight level

Turn the rotary control LUX
the motion detector
the daylight level. In position , the motion
detector only responds at pitch-black night
(approx. 5 lx). In position , the motion
detector also responds at daylight levels, as
long as about 20,000 lx are not exceeded.
Orientating the
motion detector
Loosen the fastening screws
detector .
9
Turn the rotary control LUX
Orient the motion detector into the central
region of the desired coverage area.
Move about through the coverage area until
you are satisfied with the response characteris-
tics of the motion detector. To find the proper
orientation, change the position of the rotary
control SENS or the orientation of the
17
motion detector.
Re-tighten the fastening screws
justment.
Turn the rotary control LUX
position. These can be determined during the
dawn or twilight hours during which the spot-
light should respond. Slowly turn the rotary
10
control LUX clockwise until it reacts to
16
movement within the coverage area.

Cleaning and storage

Press the ON / OFF switch
sition if you will not be using the product and
want to store it.
Check the motion detector
cell for dirt regularly. If dirt or is present,
12
remove it to guarantee flawless function of the
product.
Especially during the winter, keep the product
free from snow and ice.
10 GB/CY
on the bottom of
16
clockwise to increase
9
of the motion
7
to position .
16
to fix the ad-
7
to the desired
16
into the OFF po-
11
and the solar
9
Clean the product with a lint-free, slightly moist
cloth and mild cleaning agent.

Troubleshooting

= Fault
= Cause
= Solution
= The product does not switch on.
= The ON / OFF switch
11
= Press the ON / OFF switch
position.
= The rotary rotary control LUX
too dark.
= Adjust the rotary control LUX
= The motion detector
9
oriented.
= Clean the motion detector
= The sensitivity of the motion detector
low.
= Readjust the sensitivity of the motion detector
(see section "Adjusting the sensitivity of the sen-
sor").
= The rechargeable battery is discharged.
= Charge the rechargeable battery (see section
"Charging the rechargeable battery").
= The product also switches on when it
is light out.
= The rotary control LUX
= Adjust the rotary control LUX
= The light flickers.
= The rechargeable battery is almost discharged.
= Charge the rechargeable battery (see section
"Charging the rechargeable battery").
= The rechargeable battery loses its
charge after a short time.
= The plug connection of the solar cell
spot light has come loose.
10
= Refasten the plug connection at the product.
= The solar cell is dirty.
= Clean the solar cell.
is in the OFF position.
into the ON
11
is adjusted
16
so it is brighter.
16
is dirty or is incorrectly
or reorient it.
9
is too
9
9
is adjusted too bright.
16
so it is darker.
16
and
12