Using The Appliance - Moulinex Toucan automatic DR2 Bedienungsanleitung

Using the appliance

PUTTING IN THE OIL OR FAT
. If you are using blocks of fat, (4 blocks of
500 g):
- Take out the basket by pressing the control
1
button (C2). Cut the blocks of fat into pieces
and place these directly into the bowl without
the basket.
- Never melt the blocks of fat in the bas-
ket.
- Close the lid by pushing until it clicks.
4
- Melt the blocks by setting the function
selector (E) to 140ºC.
The display will blink until this temperature has
been reached.
An acoustic signal will sound once the right
temperature has been reached.
- Reset the temperature selector to the off
position «0».
- When the blocks of fat have liquefied, re-
place the basket / handle assembly in the
bowl by pressing the control button (C2).
3 . If you are using oil:
- Pour it inside the bowl up to the level
indicated inside between "mini" and "maxi"
(2 to 2.2 litre of oil).
You can start using your fryer.
F
RYING FOOD
. A
UTOMATIC COOKING
- Set the selector (E) to the selected
4
temperature (see cooking charts).
The display shows a pre-programmed time.
It is possible to increase or to decrease this
time in steps of 1 minute by pressing the (+) or
(-) controls (maximum 30 minutes).
Double immersion cooking
- Press control (G). A logo «
the left-hand side of the display.
First phase: pre-cooking takes about 2/3 of the
time. The second phase finishes off the
cooking.
The display flashes until cooking
temperature has been reached.
An acoustic signal warns you that the basket
is in the raised position.
- Open the lid and put in the food.
- Close the lid.
As soon as cooking temperature has been
reached, the display becomes fixed. The
basket is lowered automatically.
The cooking time will start to count down.
(1 - 2 ):
IMMERSIONS
» appears on
Notes:
. It is possible to alter the cooking time at
any point during cooking by pressing the
(+) or (-) controls.
It is also possible to raise the basket at
any time by pressing the raising / lowering
control (H).
. To resume the cooking which has already
commenced (within a maximum of 20 mi-
nutes), press the raising / lowering control
(H) again and cooking will be completed with
the remaining time.
An acoustic signal will inform you when cooking
is finished.
The display shows «0».
. Allow the food to drain.
. Open the lid and serve.
. Cooking several batches of food in suc-
cession:
- Place the food in the basket.
- Close the lid.
You can go back to the original pre-
programmed cooking time by pressing once
on the (+) control, or you can choose a different
temperature using the selector.
- To use the double immersion function, press
the double immersion control (G).
. Finishing cooking and turning off the
appliance
- Set the temperature selector to the off posi-
tion «0». The appliance will now switch off.
- The basket automatically returns to the
lowered position.
- Unplug the appliance.
Notes:
. If you do not return the selector to the
position «0»:
The basket will remain in the raised position.
The display will show zero for about 20 minu-
tes until the appliance goes into standby mode
(4 horizontal dashes flashing in the display).
When the appliance is in standby mode, the
temperature of the oil is maintained at a steady
140 ºC.
At the end of 10 minutes, the appliance
switches itself off automatically: the display
shows 4 horizontal fixed dashes.
The basket returns to the lowered position.
. Set the temperature selector (E) to the off
position «0».
. Unplug the appliance.
17