Troubleshooting - Nikon Lite Touch Zoom 70Ws QD Bedienungsanleitung

Troubleshooting

Track down the cause of trouble using the following chart.
It may save you a trip to your nearest Nikon service center.
Problem
The shutter
cannot be
released.
The flash
does not
fire.
32
Additional Information
Check points and solution
a The slide cover is not completely open.
→ Open the slide cover all the way until it
clicks to turn the camera on.
a The orange LED blinks.
→ The flash is charging. Release the shutter
after the orange LED lights up.
a The green LED blinks.
→ The subject is too close. Keep the
camera away from the subject for more
than approx. 0.8m (2.6ft).
a Letter " " lights up on the LCD panel.
→ A rewound roll of film is inside. Replace
it with a new roll.
a No indicator on the LCD panel.
→ The battery is exhausted. Replace it with
*
a new one.
a All indicators on the LCD panel blink.
→ The camera has detected a malfunction.
Once open the slide cover and close it
again, then the power is turned on. If the
camera still does not work properly,
remove the battery from the camera and
confirm the indicators turns off, then
Install the battery in place again.
a No indicator on the LCD panel.
→ Battery power is low or the battery is
exhausted. Replace the battery with a
*
new one.
a The orange LED blinks quickly.
→ Check that the flash unit is not pressed
down. Do not touch the flash unit.
a " " lights up on the LCD panel.
→ The flash does not fire when the subject
is bright enough. To fire the flash, set the
camera to the Anytime Flash mode.
Ref. page
9
7,20
15
10,11
17
8
8,9
*
8
7,20
21,23