Troubleshooting - Nikon Lite Touch Zoom 140 ED Bedienungsanleitung

Troubleshooting

Track down the cause of trouble using the following chart.
It may save you a trip to your nearest Nikon service center.
42
Downloaded from www.Manualslib.com
Problem
a The slide cover is not completely open.
→ Open the slide cover all the way until it clicks to
turn the camera on.
a The orange LED blinks.
→ The flash is being charged. Once take your finger
away from the Shutter Release button, lightly
press the button again, and release the shutter
after the orange LED stops blinking and stays lit.
a Letter " " lights up on the LCD panel.
→ A rewound roll of film is inside. Replace it with
The shutter
a new roll.
cannot be
released. a No indicator on the LCD panel.
→ The battery is exhausted. Replace it with a new
one.
a All indicators on the LCD panel blink.
→ The camera has detected a malfunction. Once
open the slide cover and close it again, then turn
the power on. If the camera still does not work
properly, remove the battery from the camera and
confirm the indicators turns off, then Install the
battery in place again.
a The orange LED blinks.
→ The flash is being charged. Once take your finger
away from the Shutter Release button, lightly
press the button again, and release the shutter
after the orange LED stops blinking and stays lit.
a "
→ The flash does not fire when the subject is bright
The flash does enough. To fire the flash, set the camera to the
not fire. Anytime Flash mode.
a No indicator or the "
panel.
→ Battery power is low or the battery is exhausted.
Replace the battery with a new one.
a The orange LED blinks quickly.
→ Check that the flash unit is not pressed down.
Do not touch the flash unit.
Additional Information
manuals search engine
Check points and solution
*
*
" lights up on the LCD panel.
" blinks on the LCD
Ref. page
13
11,31
14,15
24,25
12
12,13
11,31
32,34
35
12
*
11,31