Troubleshooting - Nikon Lite Touch Zoom 130ED Bedienungsanleitung

Troubleshooting

Track down the cause of trouble using the following chart.
It may save you a trip to your nearest Nikon service center.
Problem
The shutter
cannot be
released.
The flash does
not fire.
The subject
appears out of
focus in the print.
42 Additional Information
Check points and solution
a The slide cover is not completely open.
Open the slide cover all the way until it clicks to
turn the camera on.
a The orange LED blinks.
The flash is charging. Release the shutter after
the orange LED lights up.
a " " lights up on the LCD panel.
A rewound roll of film is inside. Replace it with
a new roll.
a No indicator on the LCD panel.
The battery is exhausted. Replace it with a new one.
a All indicators on the LCD panel blink.
The camera has detected a malfunction. Once open the
slide cover and close it again, then the power is turned
on. If the camera still does not work properly, remove
the battery from the camera and confirm the indicators
turns off, then Install the battery in place again.
a The orange LED blinks.
The flash is charging. Release the shutter after
the orange LED lights up.
a " " lights up on the LCD panel.
The flash does not fire when the subject is bright
enough. To fire the flash, set the camera to the
Anytime Flash mode.
a No indicator, or the "
LCD panel.
Battery power is low or the battery is exhausted.
Replace the battery with a new one.
a The orange LED blinks quickly.
Check that the flash unit is not pressed down.
Do not touch the flash unit.
a Camera shake.
Gently press the Shutter Release button, or use a
tripod or place the camera on a stable flat surface.
a Something in front or behind the subject is in focus.
Be sure to center the autofocus frame marks
on the subject before releasing the shutter.
When correct focus cannot be easily achieved,
use the focus lock.
*
" blinks or lights on the
*
Ref. page
15
13,29
16,17
25
14,15
*
14,15
13,29
30,32
14,15
13,29
20,31
33
22,26
27