Safety-Notice - Carromco Score 301 #2 Bedienungsanleitung

Stuck segment
or
button
Removing
broken tips
Power or
electromagnetic
interference
Warranty void if dartboard has been opened/ dismantled.
WARNING!
Different types of batteries or new and old batteries are not to be mixed!
Non-rechargeable batteries are not to be recharged.
Rechargeable batteries are to be removed from the dartboard before being
charged.
Only batteries of the same or equivalent type as recommended are to be used.
Exhaused batteries are to be removed from the game.
Batteries are to be inserted with correct polarity.
The supply-terminals are not to be short circuited.
Avoid dartboard being subjected to extreme weather or temperature.
Avoid dartboard being subjected to liquid or excessive moisture.
Clean dartboard with damp cloth and/or mild detergent only.
Please disconnect the dartboard from the power supply before cleaning.
Examine regularly the battery charger for any damage to their cord, plug,
enclosure and other parts. In the event of such damage, don`t use the dartboard
until the damage has been repaired.
WARNING!
During shipping or in the course of normal play, it is
possible for the scoring segments to become temporarily
stuck. If such a situation happens, all automated scoring
functions will cease. By gently removing the dart or
wiggling the segment with your finger, you will be able to
free the segment. The game may then be resumed and
scoring functions will be back to normal.
Soft-Tips may break and remain in the board. In this
case, try to pull them out gently with a pair of pliers. Note:
the heavier the dart, the higher the chance of bending or
breaking tip.
Should there be an electromagnetic interference, the
electronics of the dartboard may possibly show erratic
behavior or fail to continue working. (For example: a
heavy thunderstorm, a power line surge, a rolling brown
out, or too close proximity to an electrical motor or
microwave.) To restore the game to normal operation,
remove the batteries for several seconds and then
reinstall the batteries. Be sure to remove the source that
causes the interference as well.

SAFETY-NOTICE

16