Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.
Press the red 0/22KHz button to break the connection to the connected disk (disconnect =
unmount).
4.
Press the green H/V-button to connect to an attached disk again (mount).
5.
Press the yellow AN/DG-button to format the disk.
Note: When formatting, all data will be destroyed permanently.
6.
Press the blue FIND button to update the displayed information about memory usage.
7.
Press Exit to return to the previous menu.
6.17. Software Upgrade
The Software Upgrade function of the PeakTech
stored on the device as a backup on a USB storage device to transfer the saved data back to the
device or to transfer a new firmware on the device. Connect a USB memory device and open the
"Software Update" menu.
1.
Select the green H/V-button to select "Channel Data".
2.
Use the blue FIND button to backup the currently available data channel to secure the USB
storage. The following files appear on the USB memory:
3.
You can edit the files stored on the PC, the "Sattp" files contain only the transponder data
and "program" also includes transmitter already found.
4.
After editing the data, connect the USB memory to the unit again and replace the reworked
files in the Software Update menu.
Select the desired channel data update with the ◄Left/Right► and ▲Up/ Down▼ arrow
5.
keys and confirm the selection with the OK button. After a few seconds the data is loaded
into the device and can be used.
6.
The firmware is not stored as a backup file on the USB memory. A firmware update with
separate instructions can only be received on request, since a faulty update can damage
the unit.
®
9020 can be used to secure the channel data
-74-
Werbung
Inhaltsverzeichnis
