Agilent Technologies TV 303 Bedienungshandbuch Seite 254

17 Technical Information
TV 303 Controller Installation
3. Press the controller towards the bracket;
4. Turn the pump upside-down;
5. Place the bracket on the pump bottom;
6. Screw a little bit the three screws M4 in the holes on the pump
bottom;
7. Rotate the bracket until the controller is on the chosen position;
8. Tighten the screws properly;
9. Turn the pump again;
10. Plug the line cord and connect the pump cable to the pump;
11. Connect the mating connector with the jumper on the interlock
signal to start the pump.
Figure 42
254/268
Mounting 2
TV 303 User Manual / 87-901-019-01 (A)