Beninca PONY Bedienungsanleitung Seite 24

Memorising new transmitters (RADI>PP)
To memorise new transmitters with Step-by-Step function for the automation command, proceed as follows:
Press the [PGM] button to access programming or if the control unit is already in the programming menu, press [ ] until the Radi menu
1
is displayed.
Press the [PGM] button to enter the Radi function.
2
The display shows the first sub-menu PP.
Press the [PGM] button to enter the PP function.
3
The display shows the PUSH message.
4 Press the BY transmitter button that is to be associated to the Step-by-Step function within 5 seconds.
5 The display shows PRG to confirm memorisation.
The control unit goes back to the RADI>PP menu. To go back to the RADI menu, press the [PGM] and [ ] buttons at the same time. To exit
6
programming, press the [PGM] and [ ] buttons at the same time again or, alternatively, remove the power supply or wait 60 seconds.
Memorising pedestrian function (RADI>Ped)
The pedestrian function can be associated to any transmitter button. The pedestrian function envisions partial opening for 7 seconds, proceed as follows:
Press the [PGM] button to access programming or if the control unit is already in the programming menu, press [ ] until the Radi menu
1
is displayed.
Press the [PGM] button to enter the Radi function.
2 The display shows the first sub-menu PP.
Press [ ] to display the Ped sub-menu.
Press the [PGM] button to enter the Ped function.
3
The display shows the flashing PUSH message.
Press the BY transmitter button that is to be associated to the Pedestrian function within 10 seconds (e.g. if key 1 has already been
4
associated to the Step-by-Step function, key T2 can be associated to the Pedestrian function).
5 The display shows OK to confirm memorisation.
The control unit goes back to the RADI>PED menu. To go back to the RADI menu, press the [PGM] and [ ] buttons at the same time. To
6 exit programming, press the [PGM] and [ ] buttons again at the same time again or, alternatively, remove the power supply or wait 60
seconds.
Deleting transmitters (RADI>CLR)
Proceed as follows to delete a transmitter already inserted in the memory:
Press the [PGM] button to access programming or if the control unit is already in the programming menu, press [ ] until the Radi menu
1
is displayed.
Press the [PGM] button to enter the Radi function.
2 The display shows the first sub-menu PP.
Press [ ] to display the CLR sub-menu
Press the [PGM] button to enter the CLR function.
3
The display shows PUSH.
4 Press any transmitter button BY that is to be deleted within 5 s.
5 The display shows OK to confirm cancellation.
The control unit goes back to the RADI>CLR menu. To go back to the RADI menu, press the [PGM] and [ ] buttons at the same time. To
6 exit programming, press the [PGM] and [ ] buttons again at the same time again or, alternatively, remove the power supply or wait 60
seconds.
24
Radi
PMOT
PP
Push
PRG
PGM+
Radi
PMOT
Ped
Push
ok
PGM+
Radi
PMOT
Clr
Push
OK
PGM+