Replacement Of Electrical Elements; Training - CombiSteel 7472.0005 Gebrauchsanweisung

2.4 REPLACEMENT OF ELECTRICAL ELEMENTS

Heating Element (7472.0030, 7472.0035, 7472.0040, HK5, HK3A, HK9)
For heating elements and other only the right cover of the appliance need to be removed.
NHK4
For the lower two heating elements draw and remove the right painted glass at the bottom of the appliance.
Release the wires and remove the heating element's holding screws inside chamber. Draw out the heating
element and make the replacement.
To replace the upper heating element remove the right adjoining pyrex glass and the right column cover of the
appliance. Release the wires and remove the heating element's holding screws inside chamber. Draw out the
heating element and make the replacement.
For the motor unscrew supporting base of the motor (same steps for all models).
For thermostats, indicating lamps, switches, draw and remove the right painted glass at the bottom of the
appliances.
CUT OFF THE POWER SUPPLY BEFORE COVER REMOVAL.

2.5 TRAINING

The personnel who are to install and connect the appliance must train the users appropriately so that they can
handle the operation and safety measures of the appliance.
ATTENTION !!!

Check that main voltage in your working area is suitable for the settings on the label and that the appliance
is properly earthed.

Before any service activity takes place or any parts are replaced on the appliance, make sure that pains
supply is turned off.
THE MANUFACTURER CANNOT BE HELD RESPONSIBLE FOR ACCIDENTS AND DAMAGE CAUSED TO PERSONS,
ANIMALS OR PROPERTY DUE TO NONCOMPLIANCE WITH THESE INSTRUCTIONS.
www.combisteel.com
7