Installing/Removing Main Memory - Fujitsu D2831 Bedienungsanleitung

Brief description of mainboard

Installing/removing main memory

Technical data
Technology
Total size
Module size
A current list of the memory modules recommended for this mainboard is available
on the Internet at: "http://ts.fujitsu.com/mainboards".
At least one memory module must be installed. Memory modules with different
memory capacities can be combined.
You may use only unbuffered 1.8 V memory modules without ECC.
DDR2-memory modules must meet the PC2-5300U (CL5-5-5) or
PC2-6400U (CL6-6-6) specification.
If you use more than one memory module, make sure to distribute the
memory modules over both memory channels. By doing this you use the
performance advantages of the dual-channel mode.
Maximum system performance is achieved when identical memory modules
are used in Channel A and Channel B.
To simplify equipping, the slots are colour coded.
If you are plugging in the memory modules, start with the slot which
is located beside the processor (slot 1).
Slot to be used
Channel A, Slot 1
Channel B, Slot 2
Channel A, Slot 3
Channel B, Slot 4
The installation/removal is described in the "Basic information on mainboard" manual.
4 - English
DDR2 667/800 SDRAM unbuffered DIMM modules 240-Pin; 1.8 V;
64 Bit, no ECC
512 Mbytes to 16 Gbyte DDR2
512, 1024, 2048 or 4096 MByte per module
slot 4
slot 3
1
x
Channel B
Channel A
Number of memory modules inserted
2
x
x
A26361-D2831-Z212-1-8N19, edition 1
slot 2
slot 1
3 4
x x
x x
x x
x