Operation; Mode Buttons - LIVARNOLUX HG02408 Montage-, Bedienungs- Und Sicherheitshinweise

The connection terminal has to fulfill the requirements of the DIN
EN 60998-2-1 or DIN EN 60995-2-2. The kind of connection has
to fulfill the local and national requirements.
Note: The terminal block
Now attach the LED spotlight
locking screws
lock washers
Adjust the product into the desired direction. For this, you may need
to slacken the locking screws
LED spotlight
again, to ensure a secure hold.
After the fuse has been inserted or the fuse panel is switched on
again, your product is ready for use.

Operation

You can operate the product by using the included remote control
Note: Remove the insulating strip from the battery compartment
before using the remote control
Note: The product is preset to continuous light mode.

Mode buttons

You can use the Mode buttons
- switch the product on,
- select the lighting type,
- set, at which light intensity the product is being activated,
- switch the product off.
30 GB/IE
24
, spring washers
3
(Fig. D).
27
. After adjustment, tighten the locking screws
2
8
is not included in the delivery.
to the bracket
2
, flat washers
29
between the bracket
3
for the first time.
to
11
using the included
4
and tooth
28
and the
4
3
.
8
22