Operation - LIVARNOLUX HG05423 Montage-, Bedienungs- Und Sicherheitshinweise

Drill two holes (Ø 8 mm) and insert the wall plugs
bracket with the help of the screws
4
Loosen the cable gland
nection cable (not include in the product), type H05RN-F 3G 1.0 mm
through the cable gland
connection terminal
please refer to Fig. C.
Insert the connection cable into the holes of the screwless connection
terminal . Pay attention to the markings on the screwless connec-
5
tion terminal
(Fig. C).
Make sure each wire of the connection cable is completely insert into
the end of the holes of the terminal and further check the security fixed.
Then lock the terminal cover
Now attach the LED spotlight
locking screws
lock washers
Adjust the product into the desired direction. For this, you may need
to slacken the locking screws
LED spotlight
again, to ensure a secure hold.
After the fuse has been inserted or the fuse panel is switched on
again, your product is ready for use.

Operation

You can operate the product by using the included remote control
Note: Remove the insulating strip from the battery compartment
before using the remote control
Note: The product is preset to continuous light mode.
60 GB/MT
and terminal cover
7
and terminal cover
7
. The suitable length for the connecting wires
5
(L for live, N for neutral and
5
6
, spring washers
3
(Fig. D).
25
. After adjustment, tighten the locking screws
2
8
and check the tight fit.
23
and cable gland
to the bracket
2
, flat washers
27
between the bracket
3
for the first time.
. Screw the
24
, then run the con-
6
to the screwless
6
for the earth wire)
again.
7
using the included
4
and tooth
26
and the
4
3
8
22
,
2
.