Volume Memory; Select The Equaliser; Adjust The Brightness; Set The Clock - Silvercrest SBMS 30 A1 Bedienungs- Und Sicherheitshinweise

˜ Volume memory
The last used volume level will be
automatically stored .
˜ Select the equaliser
Press EQ 13 / 40 repeatedly to select:
[POP] – [CLASSIC] – [ROCK] –
[JAZZ] – [FLAT] .
˜ Adjust the brightness
Press DIMMER 35 to select the brightness
level .
˜ Set the clock
Setting of the clock can only be done in STANDBY
mode .
In STANDBY mode, press and hold
CLOCK 32 until the hour digits are flashing .
Press , 27 to adjust the hour digits . Press
CLOCK 32 to confirm . The minute digits are
flashing .
Press , 27 to adjust the minute digits .
Press CLOCK 32 to confirm .
NOTE: Each activated state will be cleared
if any buttons are not pressed within
20 seconds .
Toggling between 12/24 hour formats:
During time setup, press
NOTE: If the product is unplugged or if
a power failure occurs, all setups of the
product will be erased .
Time display
Press CLOCK 32 to show the current time on the
display for a few seconds .
16 GB/CY
˜ Set the alarm timer
15 or 42 .
Stop alarm ring
When the alarm rings, press any button . The alarm
stops but the alarm settings remain .
NOTE: The clock must be correctly set for
the timer to operate correctly .
In STANDBY mode, press and hold
TIMER 38 until the hour digits flash on the
display .
Press , 27 to adjust the hour digits . Press
TIMER 38 to confirm . The minute digits will
flash on the display .
Press , 27 to adjust the minute digits .
Press TIMER 38 to confirm . BUZZER
flashes on the display .
27 to select FM / CD / USB
Press ,
mode . Press TIMER 38 to confirm . The
display will show the volume level .
Press , 27 to adjust the volume . Press
TIMER 38 to confirm .
Short press Description
TIMER 38
1x Timer on
2x Timer off
NOTE: The operating time to set each step
must not take longer than 20 seconds or it
will return to time display .
Display
–