Adjusting The Speaker Output Levels; Before You Begin; Using The Test Tone (Test Dolby Sur.) - Yamaha RX-V800RDS Bedienungsanleitung

ADJUSTING THE SPEAKER OUTPUT LEVELS

This section explains how to adjust the speaker output
levels by using the test tone generator. When this
adjustment is made, the output level heard at the listening
position will be the same from each speaker. This is
important for the best performance of the digital sound
field processor, the Dolby Pro Logic decoder, Dolby
Digital decoder and DTS decoder.
Note
• Since this unit cannot enter the test mode while headphones are
connected to this unit, be sure to unplug the headphones from
the PHONES jack when using the test tone.

Before You Begin

1
STANDBY
/ON
PRESET/
A/B/C/D/E TUNING
TUNER
SPEAKERS BASS PROCESSOR
A B EXTENSION DIRECT
EFFECT PROGRAM
ON OFF
DSP
2 3
1
Press STANDBY/ON to
turn on the power. Turn on
the video monitor.
2
Press SPEAKERS A or B
to select the main
speakers to be used.
If you are using two sets of the
main speakers, press both A
and B.
3
Set BASS and TREBLE on the front panel to
the center position and set BASS
EXTENSION to OFF.
BASS TREBLE
+ +
– –
22
INPUT
VOLUME
INPUT MODE
D I G I T A L
D I G I T A L
SURROUND
PRESET TUNING RDS MODE
/TUNING FM/AM MEMORY MODE /FREQ EON PTY SEEK
BASS TREBLE
EDIT MAN'L/AUTO FM AUTO/MAN'L MONO MODE START
PHONES S VIDEO VIDEO L AUDIO R OPTICAL
– + –
SILENT VIDEO AUX
3
STANDBY
/ON
SPEAKERS
A B
BASS PROCESSOR
EXTENSION DIRECT
ON OFF
Set to OFF.
Using the Test Tone (TEST DOLBY
SUR.)
Use the test tone to balance the output levels of the 5
speakers required for a surround sound system. The
adjustment of each speaker output level should be made at
your listening position with the remote control. After
completing the adjustments, use VOLUME +/– at your
listening position to check if the adjustments are
satisfactory.
1
6CH INPUT
+
1
Set the selector dial to the
AMP/TUN (or DSP/TUN)
position.
2
Press TEST to output the test tone.
3
Adjust the volume so you can hear the test
tone.
The test tone is heard from the left main speaker,
center speaker, right main speaker, right rear speaker
and left rear speaker in order. The tone is produced
for 2.5 seconds each time.
2,6
5
4
3
LEFT RIGHT
(TEST LEFT) (TEST RIGHT)
CENTER
(TEST CENTER)
LEFT SURROUND RIGHT SURROUND
(TEST L SUR.) (TEST R SUR.)