Switching Library Codes; Clearing Set Up Remote Control Codes - Yamaha Rx-V657 Bedienungsanleitung

REMOTE CONTROL FEATURES

Switching library codes

You can select the unit you want to operate with the
remote control by entering the library code.
1
Press CODE SET using a ballpoint pen or
similar object.
The TRANSMIT indicator on the remote control
flashes twice.
CODE SET
2
Enter the code number "9991" or "9992" (see
the table below).
The TRANSMIT indicator on the remote control
flashes twice, and the library code is changed.
AMP library
code
(remote Function
control
setting)
To operate this unit
9991
using the default code.
To operate this unit
9992 using an alternative
code.
When using multiple YAMAHA receivers/amplifiers, you
may be able to operate the other components simultaneously
with the default code setting. In this case, set one of the
alternative codes to operate this unit separately.
Note
You must also make settings for the receiver/amplifier.
70
Clearing set up remote control
codes
1
TRANSMIT
2
Remote
control ID (unit
setting: see
page 66)
3
ID1
(initial setting)
ID2
y
• If you do not press any button within 30 seconds after step 2,
the clearing process is canceled. If this happens, start over from
step 1.
• You can clear all setup remote control codes at once by entering
the code number "9990".
Press an input selector button or
select the component control for which you
want to clear the remote control code.
CD MD/CD-R TUNER
DVD DTV/CBL V-AUX
VCR 1 DVR/VCR2
Press CODE SET using a ballpoint pen or
similar object.
The TRANSMIT indicator on the remote control
flashes twice.
CODE SET
Enter the code number "0000".
The TRANSMIT indicator on the remote control
flashes twice, and the remote control code for the
selected component is cleared.
to
SLEEP
MULTI CH IN
AMP
TRANSMIT